Please fill out the form below with as much detail as possible. Alternatively, call our free technical support helpdesk: +44 (0)1453 884461
Software Setup Videos
Please note, these videos are designed to assist customers already familiar with Aberlink 3D and are not a substitute to the standard Aberlink training courses. Click for further information on our extensive range of training.
How to setup the Aberlink reference ball
This video shows how to setup an Aberlink reference ball on an Axiom Too. This process is the same for all CNC Aberlink machines
Written work instruction also available in PDF format, click the PDF icon below to view
How to setup the MCR20 Change rack
How to setup an MCR20 Change rack on an Axiom Too. This process is the same for all CNC Aberlink machines
Written work instruction also available in PDF format, click the PDF icon below to view
Probe Calibration
How to calibrate your probes, delete probes and setup new probes using the probe manager tool in Aberlink Mk4.
Fixed Star Calibration
How to calibrate and setup a fixed star probe including how to switch between the different points of your fixed star probe.
Star Centre Calibration
How to calibrate and setup a star centre probe including how to correctly setup each stylus.
Disc Stylus Calibration
How to calibrate and setup a Disc Stylus, for further information please see the video "Fine tuning the Disk Stylus"
Fine Tuning the Disk Stylus
How to fine tune the diameter of Disc Stylus and the stud position.
Adjusting the Joystick Deadband
If your joystick is creeping in any axis, use this video to adjust the deadbands (sensitivity) of your joystick.
